|Date Added:||16 June 2014|
|File Size:||35.48 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
After capturing from your VCR you would then need to set up the tuner again in Media Center in order to use it. Example of a TV tuner system with extender – controller on tuner.
Your computer ibfrared have an extender board to connect an external IR receiver or an IR blaster cable to send the remote control signal to another device, such as a cable TV set-top box. Try reinstalling updated VGA drivers for the graphics card in the system.
The driver for the device must be installed in order to run Prodinfo. I even turned off the monitor in case that light was blinding the reciever somehow. MCE will then scan for your connected input and should indicate if you have a cable TV line, antenna, or set hauppaue box connected to your WinTV card.
Modify your browser’s settings to allow Ijfrared to execute. Upon reboot it re-installed the drivers and drove another reboot. In here it will have Media center radio listed. Use the following steps to test and reset the remote sensor:. Hauppauge Be sure the look in directory is your C: INF for a word or phrase in the file enter: How satisfied are you with this reply?
Did this solve your problem? Stretch50 Replied on January 3, Also try installing Microsoft’s “Rollup Update 2”. Go into the IP directory and you find the irbus.
For the file name enter: Point the remote control towards the remote sensor and press any button. When i disabled the reciever and rebooted the computer, nothing happened. Point the remote control at the remote sensor within a degree range, recelver less than 26 feet 8 meters away. I will have to resume the troubleshooting when i get back.
Two tuners total can be installed and configured for use in Media Center. Microsoft has addressed this issue, which can be found here.
Stretch50 Created on December 29, Choose no to select a different region and next to continue to choose your region from the list. Tell us about your experience with our site. Check your device manager for a “Human Interface Devices” listing, which should contain: It is an HPEt. Use this document when the remote control does not work incrared with the Media Center software. This software is available on our web site in the Support Applications section.
Open the file called kb Copy these two files to a temp directory. If eHome Infrared Receiver recdiver Hauppauge Consumer Infrared Receiver is not in the lists, or there is an exclamation mark or a question mark on the device, perform the following until eHome Infrared Receiver appears correctly in Device manager:.
The remote control you use needs to be compatible with Windows Media Center. Please try again shortly.